Yes - in my experience, over the course of an extraction several milliliters of alcohol will come through the vent of the membrane pump. If it's a long distillation I vent it outdoors, but the room has a ventilation system so I can also just turn that on for shorter distillations. One thing I like to do for shorter runs where I'm not so worried about a lot of alcohol vapor is to put the vent hose into a mason jar partially filled with water - the rate of bubbling gives me auditory / visual feedback on the flow of vapor... a little window into things that might otherwise not be noticeable going on in the apparatus.

it also accumulates the aroma as the distillation proceeds and it becomes cloudy with suspended droplets of what I assume are the very lightest essential oil fractions of the mixture being reduced

I have not tried heptane or hexane and I think it may actually be illegal to operate one of these with those solvents at a domestic address in the United States... so I'm sticking to alcohol until I understand things a little better.
Yes illegal. Making the tincture is legal if its small amounts but once you get to evaporation in whatever glassware it's a big no without ATEX compliant setup (fire code) and even then remains no on a domestic address (zoning law). Then you still have to deal with clean air act to the point where enfleurage in whichever variation is a less time consuming route 🙂 (talking heptane/hexane/butane and assuming Portland Oregon)
 
Last edited:
According to this topic, i have question. Does the condeser need to be screwed very tight to the main body of evaporator? There is still some place (see photo), but i dont want to break anything, it seems to be mounted quite tight, just wondering why is there still some space on the plastic screw.

Also not sure about this 19/38 part.
Whats the purpose of this part?
There is little hole in that glass piece on the left, which is going inside of the condenser.

Does this piece somehow regulate the pressure. Does the small tube need to be connected somehow to that hole?
Didnt find any informations in manual.


image.webp
 

Attachments

  • [Ouddict.com] Rotovap question
    image.webp
    111.3 KB · Views: 0
According to this topic, i have question. Does the condeser need to be screwed very tight to the main body of evaporator? There is still some place (see photo), but i dont want to break anything, it seems to be mounted quite tight, just wondering why is there still some space on the plastic screw.

Also not sure about this 19/38 part.
Whats the purpose of this part?
There is little hole in that glass piece on the left, which is going inside of the condenser.

Does this piece somehow regulate the pressure. Does the small tube need to be connected somehow to that hole?
Didnt find any informations in manual.


View attachment 57279
if you look up thread a bit you will see there are some people around here with more experience than me with these devices but my belief is that what you've got there is intended to allow you to aspirate more of your unconcentrated extract into the evaporator without shutting things down and releasing the vacuum.
 
you can put a section of tubing on the end of that stopper and feed it down into the evaporating flask, then slightly open the stopper with that tube in a flask of unconcentrated extract and it will be drawn in by the vacuum
 
Back
Top